Using TIM on STM32
Using Timer on STM32
Last updated
Was this helpful?
Using Timer on STM32
Last updated
Was this helpful?
This is rarely used. Software control of the slave device is preferred.
This is rarely used. Software control of the slave device is preferred.
This event is generated when counter overflows or underflows.
This event is generated when the counter is equal to the channel pulse value. Think this as the PWM signal.
However, note that when using "Active level on match" or "Inactive level on match", it will only generate one trigger event on TRGO and will not be reset.
set CH Polarity to Low.
Do not change PWM Mode. The internal logic is still operating in "PWM mode 1" mode.
e.g. Setting CCR to 0 makes the channel always inactive, while setting CCR to ARR makes the channel always active.